These panel antennas can be used for either US RFID or ISM applications. They are designed to operate in close proximity to metal, which normally has a tendency to detune antennas. An optional mounting kit is available for mounting the antenna to forklifts, shelving gates or racks. The antenna is available in either right-hand or left-hand circular polarity. (Please specify when ordering) Manufactured by Mobile Mark

• Band: US RFID, 915 MHz
• Frequency: 902-928 MHz
• Gain 7 dBic gain
• 902 - 928 MHz (US) 865 - 870 MHz (EU) 7 dBic maximum 1.5:1 max over range 50 Ohm nominal
• 20 Watts
• 70o elevation, 70o azimuth 15 dB or better
• -40oC to +85oC
• 4 Hole Corner Mount,
• 6.75" Hx 6.75" Wx 2" D (172 mm x172mm x 50 mm)
• 1.1 lbs (0.5 kg) Black ABS
• 1 ft (30 cm) RG-58/SMA male Integral N female
• Built in 10k ohm resistor for reader with "sensing" circuits. Model FL-MK mounting kit, allows PN7 mounting on forklift load backrest
• EN 61373, IEEE 1478, MIL-810G TIA 329.2-C
• IPx7

Manufactured by Mobile Mark  "This antenna is made to order and requires 4-5 weeks before shipping."

Mobile Mark’s RFID Panel Antenna (PN7 Series) is designed to operate in close proximity to metal, which normally has a tendency to detune antennas.  The antenna can even be mounted directly against metal as would be the case for antennas installed on the load backrest of a forklift assembly.

Although this antenna is frequently referred to as a “forklift” antenna, it can be used for any mid-distance installation.  The low profile and rugged exterior makes it a natural addition in many industrial or rugged setting.

The PN7 Series antenna provides 7 dBi gain.  It is either left-hand or right-hand circularly polarized and must be paired with another similarly circularly polarized antenna to optimize the point-to-point link.  Circular polarity helps the antenna overcome many polarization issues such as non-alignment or cross-alignment, and minimizes reflected signals from unwanted surfaces.

This durable, low profile antenna measures only 6.75”H x 6.75”W x 2”D.  It is available in 2 styles: a direct N connector version, as well as a coaxial “pigtail” version.  Jumper cables can be supplied for either version to accommodate a variety of installations.  An optional mount kit (clamp mounting adapter) is available to adapt the antenna for metal setting such as forklifts, shelving, gates or racks.

Special Note: Some models of RFID readers have an antenna present sense circuit, detecting a 10K ohm resistance. The PN7 Series now offers this as a standard feature.